Torsion Bars are available for Porsche 356 A and B chassies. Please choose from our selection of hollow and solid bars.
Please note: Bars for 356 Pre-A, C and SC are shorter than for A and B series cars (553mm vs. 672mm length). In order to use these torsion bars on Pre-A and C chassis, the spring plates needs to be replaced with either our Quickchange Spring Plate for 356, or factory spring plate for A or B chassis cars.
Plated & Plugged Hollow Torsion Bars
Sway-A-Way Solid Torsion Bars
QuickChange Hollow Torsion Bars
Sway-A-Way Hollow Torsion Bars
Our Plated & Plugged Hollow torsion bars are the best available. The ends are plugged to prevent moisture entry that rots ordinary hollow bars from the inside out. The entire bar is zinc plated for superior protection.
Excellent quality control means proper spline fit and spring-rate consistency bar-to-bar. Inferior quality competing bars fail on all counts.
Hollow bars provide a nice weight savings over equivalent spring rate solid bars, especially true of the heavier rear bars. This is a great way to trim extra pounds from the back of your car.
The size given is a solid-bar-equivalent. Actual hollow bar measures about .5mm larger
QuickChange Torsion Bars are Plated & Plugged and include a female threaded end that you can engage with a bolt to use as a handle for easier extraction / insertion.
Use the rears bars in combination with our QuickChange Spring Plate products for fast torsion bar swapping and re-indexing. QuickChange Torsion Bars can be extracted through the QuickChange Spring Plate without removing any bolts. Alignment settings are maintained. You don't even need to remove the wheel from the car. Changing torsion bars is a 5 minute per side operation!
QuickChange Torsion Bars make it easy to dislodge a stuck bar (factory spring do not allow the bars to be extracted without removing the plates).
A QuickChange Insert is available separately for converting your existing hollow torsion bars.
Solid bars provide a good solution for suspension builds on a more modest budget. Lacking the benefits of our high-end products, they still deliver the basic torsion bar sizing needed to customize your performance.
Hollow Sway-a-way bars provide a good solution for suspension builds on a more modest budget. Lacking the benefits of our high-end products, they still deliver the basic torsion bar sizing needed to customize your performance.
QuickChange Insert - A QuickChange Insert is available separately for converting your existing hollow torsion bars.